Allpar Forums banner

Where is the crank position sensor on a 1990 new yorker landau 3.3l v

6563 Views 12 Replies 5 Participants Last post by  Oklahoma Wolf
I'm sorry i'm probably asking one of the easiest questions. But, I am new to cars and this is my first one. Can someone help me locate this?
1 - 5 of 5 Posts

· What sanity?
Joined
·
495 Posts
It's on the transmission bellhousing in the back. There are three wires and a connector on it. Best accessed from above by reaching down past the brake booster.
 

· What sanity?
Joined
·
495 Posts
That's the O2 sensor.



The red arrow in this pic points to the hole where the crank sensor goes. You're looking at a Chrysler 4 speed tranny from behind... the plastic bags are where the axles go.
 

· What sanity?
Joined
·
495 Posts
Not sure I can make it much clearer than this:



Red arrow is the crank sensor, blue arrow is the connector. The sensor is a round black cylinder held in with a 10mm bolt. The connector is a round black 3 pin connector.

It's way down there under the brake master cylinder, bolted to the transmission.
 

· What sanity?
Joined
·
495 Posts
Electrical tape doesn't work so well either under the hood - best way to repair wiring is with a soldering iron, heatshrink tubing, and a hot air gun to shrink said tubing. Of course, it's hard to work with an iron in tight places like that, too.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top