We're looking at this thing and wondering if the driveshaft must be removed to get the pump of of the car. FSM is about no help, just says to unbolt and remove, shows picture of the 4 cylinder which is easy. V6 appears to be in the difficult to impossible range.
KOG
No help from utube, FSM, etc. We finally got the thing out, the new one back in. I can tell you that it involves various 1/4 to 3/8 and 3/8 to 1/4 adapters, looong extensions, an air wrench to remove and replace the pulley which has to be removed before the pump will come out and which cannot be reached until the pump is unbolted and removed from behind the frame. Takes minimum of two people and two lights as well. Figure about 6 hours maybe.
Just getting the belt out of this thing is a challenge.
There will NOT be Hyundai in my fleet.
Just getting the belt out of this thing is a challenge.
There will NOT be Hyundai in my fleet.
You went through all that and it's not even your vehicle? I sure hope it was someone close to you.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
